Request Information
Hardened aerospace grade stainless steel is used to produce all of ICL's die sets. The 3mm to 16mm dies are used primarily for KBr pellets for transmission analysis by IR spectroscopy, while the larger dies are most commonly used for producing briquettes for XRF spectroscopy.
Unit of Measure

Height

 N/A 5.85 Inch148.7 mm

Plunger Height

 N/A 2.76 Inch70 mm

Single Anvil Height

 N/A 0.47 Inch12 mm

Base Diameter

 N/A 3.54 Inch90 mm

Vacuum Tube

N/A 0.25 Inch6.35 mm

Load Limits

 N/A 35 t

N/A All ICL dies have an upper and lower stainless steel section for ease of disassembly and they are sealed with viton seals. For ease of use, the weight was reduced in all die sets in the 13mm to 40mm range by adding an outer shield of aluminum. This feature makes them much easier to handle than 2 piece dies made completely from stainless steel due to their lighter weight, but without sacrificing strength or durability. The dies can be evacuated with a vacuum pump to reduce the moisture in the sample.

To enable preparation of the finest quality pellets and briquettes, anvils are optically polished to a mirror finish and are free from scratches or digs. All die sets in the 13mm to 40mm size range are available with optional extremely hard tungsten carbide polished anvils for use with abrasive samples.

Features: Aerospace grade hardened stainless steel. Optically polished anvils. Evacuable.